top of page

Somfy RTS

How to program your RTS Remote
Before You Begin

Motors are shipped without limits and are not paired to remotes. 
Only supply power to the RTS motor you are programming. 
Motors will automatically exit programming after 2 minutes of inactivity. 

Note

A "jog" is a brief up and down motion of the curtain.
If you set a limit incorrectly, continue to program as limit adjustments can be made after.

Step 1: Connect Power

With the motor installed, connect power and ensure proper wiring. 

Step 2: Initiate Programming

Choose your transmitter (remote) and the channel you want to use.
Press the UP and DOWN buttons at the same time until the motor jogs.

Up Down.png
Step 3: Check Directions

Press UP or DOWN. 
When pressing the button, the curtain should travel in that direction.
If the curtain travels in the opposite direction, you need to reverse the direction.
Press and hold the MY button until the motor jogs and test the direction again.

My.png
Step 4: Set Upper Limit

Bring the motor to the desire upper limit.
Press both the DOWN and MY button until the motor starts to move, then release.
Stop the motor using the MY button before it reaches the bottom.

My Down.png
Step 5: Set Lower Limit

Bring the motor to the desire lower limit.
Press both the UP and MY button until the motor starts to move, then release.
Stop the motor using the MY button near the center of the opening.

Up My.png
Step 6: Confirm Limits

Press and hold the MY button until the motor jogs.
This will confirm you limits.

My.png
Step 7: Exit Program Mode

Press and hold the PROGRAM button on the back of your remote until the motor jogs.
This will exit the programming mode and enter user mode.
Double check your limits.

Program.png
Programming Complete

You have completed programming.
Please confirm the limits to ensure they are appropriately set.

bottom of page